Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
uPanel and Arduino - Signal issues
#3
Dear antimix,
1) you have to disconnect the RX (pin D0) of Arduino UNO because during upload of the sketch the IDE transmit to Arduino through that serial port. This does not depend from the miuPanel module, it is a general practice to do. The TX pin of Arduino is not important during the sketch upload.

2) Here, you make confusion! You have confused the "standard baudrate during upload if the sketch" (you have not change this settings!) with the baudrate in your sketch used for your application (Serial.Begin(57600))! This are two different things.
Reply


Messages In This Thread
uPanel and Arduino - Signal issues - by antimix - 09-15-2016, 09:34 PM
RE: uPanel and Arduino - Signal issues - by Technomaker - 12-28-2016, 10:25 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)